HOLOTECH Technology reliably removes toxins from emissions generated by industrial, commercial, and private fossil fuel burning vehicles.
Anti Smog Treats Up To 75 gal Tank: MFC (magnetic fuel chip) deletes exhaust emissions by pre-treating 78 found chemicals in unleaded fuel emissions.
Gasoline MFC pre-treats the fuel in the holding tank through a frequency field when placed on the STEEL frame next to tank within 8 inches. During the pre-treatment of fuel, trace toxin molecules are neutralized.
When the pre-treated fuel reaches the engine cylinders combined with air, the combustion process is more complete. The toxins that have been rendered inert in the fuel treatment reduce emissions as well improving fuel efficiency. The average increase in fuel economy for gasoline engines is 5% - 25% and 10% - 40% for diesel engines.
The emissions produced in non-treated fuels, emit dangerous quantities of Sulfur Oxide (SOx), Nitrogen Oxides (NOx), Carbon Monoxide (CO) and Carbon Dioxide (CO2). For decades these commonly known toxins have been proven to cause serious threats to our environment and health.
The emissions produced worldwide have shown a monumental impact on the overall health of the environment and the quality of our lives. The solution is complex yet simple.
We provide that complex solution in a simple way to ensure our future will be sustainable with a clean and healthy environment. MFC are a form of digital homeopathy which uses informational code sets (of energetic essences) embedded into the "chip" to help amplify frequencies you want and help negate frequencies you don't want in your field.
MFC has several products (codes sets) geared toward whatever area of total wellness you are looking to improve.
ANTI-SMOG DIESEL 75-300GEL FUEL CHIP: Place the Magnetic Fuel Chip on your car or trucks STEEL frame next to your gas tank within 8 inches for improved emissions (0-CO,0-NOx), and a cleaner, better burning engine. Miles Per Gallon has been reported to INCREASE 5% – 25% in most cases of gasoline burning engines (up to %40 in diesel engines) to occur in vehicles that are in good working condition.
Locate the vehicle’s fuel tank. If you have a skip plate, have an authorized mechanic show you where the fuel tank is. If there are two fuel tanks, you will need two fuel chip devices. Make sure that you have the correct fuel chip for your vehicle depending on whether it is petrol, diesel or LPG.
Before installing the fuel chip next to the tank, take note of the smell coming from the exhaust.
Most cars will have a distinct smell of gasoline coming from the tailpipe. The fuel chip, when next to unleaded fuel starts to work in 30-60 seconds to neutralize toxins in the fuel. The fuel is pre-treated before combustion, not after like catalytic converters or other post combustion devices.
Place the magnetic fuel chip on the STEEL frame next to the fuel tank within 8 inches. To secure the MFC place the MFC in between a gap if possible or wedge and press firmly.
Most cars will experience a slight lowering of the idle instantly. After revving the engine for about 30 seconds to 1 minute, observe the quality of the exhaust from the tailpipe. There should be mostly water vapor coming out and steam-like smell.
Now your exhaust emissions are greatly reduced and in time, as your engine cleans out accumulated deposits, your gas mileage will improve along with an increase in engine life.
The fuel chip reduced your idle RPMs and will help your engine run with lower emissions, possibly even 0.0 while increasing power and performance noticeably. Increase in power and performance will be seen right away mileage increase on older cars takes a couple oil changes.
The view at HOLOTECH is that yes, we have impacted our environment, and also our own well-being. In response we have developed solutions that have the potential to eliminate this threat and in many cases, repair the damage.
Our devices remove a wide range of pollutants including:
Emissions Reduction Device was developed by sampling vehicular tailpipes.
The recorded frequency was then inverted with processes that are in some ways similar to those commonly used with sine waves.
These steps create a Key Signature that is designed to completely erase its target. For the purposes of manipulating vehicular exhaust Holotech uses a static application.
In this case a small device, capable of generating and sustaining a Scalar Field, with no moving parts and requiring no batteries. Using an electromagnetic process, Holotech embeds the Key Signature into a specially engineered image, causing it to generate a small scalar field that radiates the new frequency.
For the process to be successful, the scalar field must come in contact with the fuel itself, so the newly programmed MFC device is attached directly to the STEEL frame next to the vehicle’s fuel tank within 8 inches
As the fuel comes in contact with the field, its Key Signature changes to match the new frequency. Quantum Absorption then enables the frequency to affect the remainder of the fuel.
The improved fuel now burns completely, while consuming any waste residue left as a result of previous incomplete combustion.
The end effect includes reduced emissions, fuel savings, and increased performance.